Method of use and maintenance

Operation&Maintenance Manual of Rubber Conveyor Belt

1. Direct sunlight or drenching should be avoided during conyeyor belt in trans and in storage.Prevent the contact withsubstances such as acid,alkaline and oils an organic solvenl and so on.and rubber belt should be placed over one meter away from a heat source.

2. The warehouse temperature should be fanging-18'C-40'C,and the reative humidity During 50-80%storage.

3. The products should be palced by rolls and should not be enfolded.

4. They should be turned and moved once a quarter dutring storage.

5. Conveyor belts of different type, specs and layer Should not be spliced and used.For splicing,the best way is viaagglutination method.
6. The matching of drive durm diameter and the number of bell layers,the collocation of the drive drum withturnaboutdrum,and the requirement on the well,angle of carrying roller should be stipulated in accordance with the conveyor designand selected reasonably.
7. Feeding should be performed in the same direction as the belt running.To reduce the impact of the failing material doneto the bell,chutes shall be set up to reduce the materials falling distance.The section that Joads materials of rubber belitshould use shorter carrying roller pitch and buffer foller to prevent spillage The sides of the belt should adopt striker plate ofproper,llexiblity lest rigid striker plate scratch and damage the surface of the belt.

8.The following attention should be paid during operation:

(1) It should provent the carying roller from being covered with material,which wouid result in lurning failure; Preventionof the fallen materials being iammed between drums and belts,Altention should be paid fo the lubrication on moving parts,andit should not contaminate the belts.
(2) Loaded stat-up should be avoided.
(3) A limely correction shall be carried out when olfl-track occurs.Timely mending shall be done when there is a partialdamage on the surface of the belt,to prevent the damaged parts form being expanded.(4)To prevent the belt from being bicoked by the frame,supporting pillar and lump materials.